Operation on the Home Screen ......16 download the latest edition of the Instruction Manual How to Use the Navigation System for reference. (DNN9250DAB/ DNN6250DAB) ......17 ✎ NOTE How to Play Music ...........19 • The panels shown in this guide are examples used to provide clear explanations of the operations.
Kenwood dealer. Ñ Precautions on using this unit • When you purchase optional accessories, check with your Kenwood dealer to make sure that they work with your model and in your area. • 8-cm (3 inch) discs cannot be used.
Ñ Acquiring GPS signal Ñ How To Reset Your Unit (DNN9250DAB/ DNN6250DAB) If the unit or the connected unit fails to operate properly, reset the unit. The first time you turn on this unit, you must wait while the system acquires satellite signals for the Press the <Reset>...
It does not reflect road follow the instructions in this manual. Neither closures or road conditions, weather conditions, or Kenwood nor Garmin shall be liable for problems other factors that may affect safety or timing while or accidents resulting from failure to observe the driving.
• This unit becomes the Wi-Fi access point • Gmail (by Google) and you can enjoy music and video in a • Google calendar (by Google) smartphone Wi-Fi connected by Kenwood • Dropbox Wireless Link. * DNN9250DAB/ DNN6250DAB only ñ English...
Touch the corresponding key and set the First Step item. Power on the unit and perform some setup steps before using. Press the <8HOME> button. DNN9250DAB/DNR8025BT Language Setup DNR8025BT Select the language used for the GUI and input methods. Default is “English (United States)”. HOME 1) Touch [Language Setup].
• You can register yourself via the Web. After setting, touch [Enter]. http://www.route-collector.com/ Angle (DNN9250DAB/DNR8025BT only) • This step may be skipped if you have already Adjust the position of the monitor. Default is “0”. registered yourself in the Route Collector site.
Page 9
Ñ How to prepare the remote control Touch [Finish]. (DNN9250DAB) ✎ NOTE Insert two “AAA”/“R03”-size batteries with the • For details on operations of each setting, refer to the poles aligned properly, following the illustration Instruction Manual. inside the case.
Functions of the Buttons on the Front Panel Ñ DNN9250DAB/ DNR8025BT DNR8025BT HOME Ñ How to insert an SD card (DNN9250DAB) 1) Press < > button for 1 second. The panel fully opens. 2) Hold the SD card as the illustration in the right and insert it into the slot until it clicks.
Page 11
Name/ Motion Name/ Motion s (Reset) SD card slot (DNN9250DAB) • If the unit or the connected unit fails • A slot to insert an SD card. to operate properly, the unit returns to initial settings when this button is pressed (Instruction Manual P.151).
Page 12
Ñ DNN6250DAB Ñ How to insert a microSD card 1) Slide the Release key upward to detach the part of the front panel. 2) Hold the microSD card with the label side facing left and the notched section up, and insert it into the slot until it clicks. To eject the card: 1) Push the card until it clicks and then remove your finger from the card.
Page 13
Name/ Motion Disc insert slot • A slot to insert a disc media. G (Eject) • Ejects the disc. • Pressing for 1 second ejects the disc forcibly. s (Reset) • If the unit or the connected unit fails to operate properly, the unit returns to initial settings when this button is pressed (Instruction Manual P.151).
Common Operation etc. Touch keys with various functions are displayed here. Displayed keys differ depending on the current Ñ General audio source, status, etc. There are some functions which can be operated For examples, see List screen (P.27) in the from most screens.
Slide the Release key upward to detach You can detach the front panel to prevent theft. the part of the front panel. Then, detach the panel as the diagrams Ñ DNN9250DAB/ DNR8025BT below. Press the <0> button for 1 second to open the front panel.
Login Press the <HOME> button to turn the power on. Select the login user. Enter the password. (Password) Enter the registered password. If you selected Administrator or Guest, this screen is not displayed. [Auto Login?] 1 Service panel Checking this checkbox allows you to log in to the Weather widget: Displays the weather forecast for system automatically from the next time.
(All source list) 3) Drag the icon to an empty space. Displays all sources. How to Use the All source list Navigation System (DNN9250DAB/ DNN6250DAB) DNN9250DAB 1) Press the <NAV> button to display the navigation screen. DNN6250DAB 1) Press the <HOME> button.
3) Touch [Go!]. signs and to use safe driving judgment at all 4) Touch [Add to Active Route] to add this stop times. Garmin and JVC KENWOOD will not be before your final destination. responsible for any traffic fines or citations that Taking a detour...
Updating maps You can purchase updated map data from Garmin or ask your Kenwood dealer or Kenwood service center for details. 1) Go to www.garmin.com/Kenwood. 2) Select [Order Map Updates] for your Kenwood unit.
Page 20
NOTE • It applies when you set the iPod/iPhone connection Basic operations from this screen with cable. SD card Plays or pauses. DNN9250DAB DNN6250DAB 1) Press the <G> 1) Detach the front Stops playing. button for 1 second panel and insert the to open the front card.
The list is refined by the item you selected. Name/Motion 3) Touch the desired item. • Searches the next/previous content or file. • Scrolling from center of display to left or right performs fast backward or fast forward. To stop fast backward/forward, touch center of the display.* •...
5) Touch [4] or [¢] in the sub function 8) Enter PIN code form the cell-phone. menu. Registering is completed. Auto memory starts. The PIN code is set to “0000” as default. Recalling the preset station Connect your cell-phone to the unit. 1) Touch [P#].
Call using the phonebook Installation 1) Touch [ Ñ Before Installation 2) Select the name from the list. 3) Select the number from the list. Before installation of this unit, please note the 4) Touch [ following precautions. Call using the preset number WARNINGS 1) Touch [Preset #] to start calling the •...
Page 24
(3 m) the Bluetooth antenna and WI-FI receiver. Bluetooth antenna area 5 ...1 ...1 M4 x 8mmMAX REMOTE WiFi iPod/ • * DNN9250DAB/ DNR8025BT only N/OUT Recever AV-IN2 5V=500mA • * DNN9250DAB/ DNN6250DAB only DNR8025BT WI-FI receiver • * DNN9250DAB only...
Page 25
Ñ Unit Ñ Attaching the front panel (DNN9250DAB/ DNR8025BT) 1) To prevent a short circuit, remove the key from the ignition and disconnect the ¤ terminal of Hold the front panel securely so as not to drop it the battery.
Page 26
1) Check the installation position of the microphone (accessory 8) and the Push-To-Talk GPS antenna is installed inside of the car. It should switch (accessory 9 : DNN9250DAB only). be installed as horizontally as possible to allow easy 2) Clean the installation surface.
Page 27
Ñ Removing the trim plate Ñ Removing the unit 1) Remove the trim plate by referring to step 1 in 1) Engage the catch pins on the extraction key “Removing the trim plate”. (accessory3) and remove the two locks on the lower level.
Connect to vehicle’s reverse lamp harness To CMOS-3xx series (Optional when using the optional rear view camera. Accessory) camera control terminal Green/White Accessory 6: GPS Antenna (DNN9250DAB/ DNN6250DAB only) FM/AM antenna input Accessory 9: Push-To-Talk Switch (DNN9250DAB Accessory 8: Bluetooth Microphone only)
Page 29
Ñ Connecting wires to terminals DNN9250DAB/ DNN6250DAB Fuse (10A) Fuse (10A) DNR8025BT HDMI/MHL HDMI/MHL M4 x 8mmMAX M4 x 8mmMAX REMOTE REMOTE iPod/ iPod/ AV-IN/OUT AV-IN2 AV-IN2 AV-OUT AV-OUT AUDIO AUDIO POWER POWER Color and functions Accessory 1 Yellow Battery...
Page 30
(iPod/ AV-IN2 switchable) HDMI/ MHL connector iPod/ USB terminal (0.8m) iPod/ USB maximum power supply current : Fixture USB terminal (0.8m) (DNN9250DAB only) USB maximum power supply current : 500 mA DAB antenna CX-DAB1 (DNN9250DAB only) (Optional accessory) Rear Preout...
iPod/ iPhone/ Android setup iPod/iPhone (sold separately) Ñ Android connection To connect the Android device with this unit, the cable (sold separately) and the profile which Lightning to USB Cable your Android device supports are necessary as (accessory of the iPod/iPhone) follows: ...
Page 32
iPod/iPhone connection setup Made for Type When you first select iPod as a source, the setting • iPod nano (6th generation) screen of the iPod/iPhone connection will appear. • iPod nano (5th generation) • iPod nano (4th generation) Press the <HOME> button twice to the •...
Page 33
Select the way to connect the device with this unit. When selecting [iPod/iPhone] If a connectable Bluetooth device is not displayed, touch [Search] and do the pairing of the devices. • “iPod connection setup” also appears when the unit is reset. For the setting items refer to iPod/iPhone •...
• The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by JVC KENWOOD Corporation is under license. Other trademarks and trade names are those of their respective owners. • The “AAC” logo is a trademark of Dolby Laboratories.
Page 35
• The terms HDMI and HDMI High-Definition COMPLIANCE WITH THE MPEG-4 VISUAL STANDARD Multimedia Interface, and the HDMI logo are (“MPEG-4 VIDEO”) AND/OR (ii) DECODING MPEG- trademarks or registed trademarks of HDMI 4 VIDEO THAT WAS ENCODED BY A CONSUMER Licensing LLC in the United States and other ENGAGED IN A PERSONAL AND NON-COMMERCIAL countries.
Page 36
Collector” User’s Agreement (“Agreement”) sets forth issues between Users. the terms and conditions for use of the KENWOOD Route Network Service “Route Collector” provided by (4) Should any third parties suffer losses or damages JVCKENWOOD Corporation (“Service”) to the users...
Page 37
(12) Other acts deemed inappropriate by us 9. User Information In order to take advantage of the Service, the User 5. Compensation Claim must first register user account name, password, Should any complaints, lawsuits or similar claims be the User’s valid e-mail address and arbitrary asserted against us by other Users or third parties for User’s information via the next page (collectively any reasons attributable to the User in connection...
Ñ Information on Disposal of Old Electrical Ñ The marking of products using lasers and Electronic Equipment and Batteries CLASS 1 (applicable for EU countries that have adopted separate waste collection LASER PRODUCT systems) Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste.
Page 39
1999/5/CE. määrustele. JVC KENWOOD timto prohlasuje, ze Latviešu Par la présente, JVC KENWOOD déclare que ce DNN9250DAB/ DNN6250DAB/ DNR8025BT je DNN9250DAB/ DNN6250DAB/ DNR8025BT est ve shode se zakladnimi pozadavky a s dalsimi Ar šo, JVC KENWOOD, apstiprina, ka conforme aux exigences essentielles et aux prislusnymi ustanoveni Narizeni vlady c.
Page 41
2.401 GHz – 2.483 GHz • This adapter has been designed exclusively Transfer rates (MAX.): for use with Kenwood car receivers. Do not 802.11n (130 Mbps) use this adapter with any other car receiver. 802.11g (54 Mbps) • The Wi-Fi CERTIFIED Logo is a certification 802.11b (11 Mbps)
Page 42
Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC Declaration of Conformity with regard to the RoHS Directive 2011/65/EU Manufacturer: JVC KENWOOD Corporation 3-12 Moriya-cho, Kanagawa-ku, Yokohama-shi, Kanagawa, 221-0022, Japan EU Representative: JVCKENWOOD NEDERLAND B.V. Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands...
Page 43
5617 est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 1999/5/CE. S tem JVC KENWOOD izjavlja, da je ta QAU0569/W02-5617 v skladu z Par la présente, JVC KENWOOD déclare que ce QAU0569/W02-5617 osnovnimi zahtevami in ostalimi ustreznimi predpisi Direktive 1999/5/EC.