Ipod Operations - Clarion CZZ09 Owner's Manual

iPod Operations
This section describes operations when
connected to an Apple iPod via the USB cable.
Notes:
• See the iPod Owner's Manual for details
regarding operations.
• The unit will not operate, or may operate
improperly with unsupported versions.
• For
a
list of Apple iPod models compatible with
this unit, please contact your Clarion dealer or
www.clarion.com.
• Made for iPod means that an electronic
accessory has been designed to connect
specifically to iPod and has been certified by the
developer to meet Apple performance
standards.
Apple is not responsible for the operation of this
device or its compliance with safety and
regulatory standards.
iPod and iTunes are trademarks of Apple Inc.,
registered in the
U. S.
and other countries.
Connecting
an
iPod
When an iPod is connected to the USB cable,
the "Shuffle" setting on the iPod will become as
follows:
• "Shuffle (Albums)" play
~
Random play
• "Shuffle (Songs)" play
~
All random play
The iPod has two modes: the "Play mode" and
the "iPod menu mode" for selecting tracks.
Switch between these modes by pressing the
[BND] button.
Note:
• To connect an iPod, please use the USB cable
that came with your iPod.
Select iPod mode
1. Press the [SRC] button.
Playback will begin from the last file that was
played on the iPod.
Notes:
• The following operations in Play mode operate
the same as in CD mode: .
*
Track selection:
[~], [~]
*
Fast·forwardlfast·reverse:
[~], [~]
*
Pause"
[ENT]
" ~/II
See "CDIMP3IWMA Operations" (page 11-13)
for details.
• After
a
Podcast file has completed playback, the
pause display, or the track-end position Play-
Time display will appear. At that time, select
a
music file once again.
• If the iPhone is used for telephone call in the
other operation mode and you wish to switch to
the iPod mode, you must finish the telephone call
and press the
[~~11]
button to enter the iPod
mode.
Setting iPod simple mode
Use this function if you wish to operate through
your iPod connected to this unit via the USB
cable.
*
The factory default setting is "OFF'.
1. Press and hold the [DISP] button (1 sec.).
2. Press [1+1II] or
[~]
to select "S-CTRL".
3. Press the
[~~11]
button.
4. Turn the [ROTARY] knob to select "ON" or
"OFF".
• ON: Operations can be made through your
iPod.
• OFF: Operations cannot be made through
your iPod.
5. Press and hold the
[~~11]
button (1 sec.) to
store the setting and return to the previous
mode.
Notes:
• When performing iPod operations using simple
control mode, make the operations slowly.
If
repetitive operations are performed too quickly,
unforseen errors may occur.
• Some iPod models do not support this function.
Consult your nearest Clarion dealer or website to
confirm which models do not support this
function.
CZ209
17