Table of Contents
Advertisement
Section 3 - Configuration
Network Setup allows you to configure your LAN and Internet settings.
DHCP:
Select this to allow your camera to get an IP address automatically
from your router or Internet service. If you are not sure which
LAN settings to use, try using DHCP mode first.
Connection:
Select this to manually set the IP address information for your
camera.
Static IP Address:
Enter the IP address the camera should use.
IP Address:
The fixed IP address.
Subnet Mask:
Enter the subnet mask that the camera should use. The default
value is "255.255.255.0. This option is used to determine if the
destination is in the same subnet.
Default Gateway:
Enter the default gateway that the camera should use. The
gateway is used to forward frames to destinations in a different
subnet. Invalid gateway settings may cause transmission
failure.
Primary DNS:
Enter the IP address of the primary DNS server that the camera
should use. The primary DNS translates domain names to IP
addresses.
Secondary DNS:
Enter the IP address of the secondary DNS server that the
camera should use. The secondary DNS is used as a backup
for the primary server.
Note: If you need to use a static IP address and you do not know the network information, contact your Internet Service
Provider (ISP) for assistance.
D-Link DCS-7510 User Manual
SETUP > Network Setup
39
Advertisement
Table of Contents
