D-Link DCS-7510 User Manual page 44

Section 3 - Configuration
RTSP URL:
This setting allows you to set a suffix for your
camera's RTSP URL so you can view your
camera's video with this video profile's settings.
For example, if you enter "mpeg4" as your RTSP
URL setting and your camera's IP is 192.160.0.20,
you can view your camera's video with these
settings through 192.160.0.20/mpeg4.
IR LED:
You can setup the IR LED to auto or manual.
• Auto – Camera sensor will auto turn on/off when
• On/Off – User can turn On/Off the built-in IR
Enable Speaker:
Checking this box will enable you to send audio
to an external speaker (not included) attached to
the external speaker jack of your camera. This will
allow you to speak with another person through
your camera.
Volume:
This sets the volume level of the external
speaker.
Enable
Checking this box will enable you to listen to audio
Microphone:
picked up by the microphone. This will allow you to hear what is happening near your camera.
Volume:
This sets the volume level of the incoming audio.
Note: Higher frame size, frame rate and bit rates will give you better video quality, but they will also require more
network bandwidth. For best viewing results on a mobile phone, we suggest setting the Frame Rate to 5 fps and bps
to 20 Kbps.
Click the Save Settings to save your changes, or click Don't Save Settings to discard your changes.
D-Link DCS-7510 User Manual
the sensor detect the environment is in
low illumination.
LEDs. This function is very useful under
low illumination environment. Note that
the live view will turn to black and white
mode when IR LEDs turned on.
44