Network Setup - D-Link DCS-2670L User Manual

Section 3: Configuration
Use this section to configure the network connections for your camera. All relevant information must be entered accurately. After making your
changes, click the Save Settings button for them to take effect.
LAN Settings: This section lets you configure settings for your local area network.
DHCP: Select this connection if you have a DHCP server running on
your network and would like your camera to obtain an IP address
automatically.
Static IP Client: If your network uses a fixed routes, you may need to obtain a fixed IP
address from your network administrator for your camera. A static IP
address may simplify access to your camera in the future.
IP Address: Enter the IP address that the camera will use on your network. You may
need to get this information from your network administrator.
Subnet Mask: Enter the subnet mask that your camera will use on the network.
The default value is "255.255.255.0. " This is used to determine if the
destination is part of the same subnet.
Default Router: Enter the address of the router or gateway your camera will use on the
network. The gateway is used to forward frames to destinations in a
different subnet. Invalid gateway settings may cause transmissions to a
different subnet to fail.
Primary DNS: Enter the primary domain name server that translates names to IP
addresses.
Secondary DNS: Enter the secondary domain name server used to back up the Primary
DNS.
Enable UPnP Enabling this setting allows your camera to be configured as a UPnP
Presentation: device on your network.
D-Link DCS-2670L User Manual

Network Setup

26