Auto Timer - Danby Premiere DPAC Owner's Use And Care Manual

OPERATING INSTRUCTIONS (cont'd)
The AUTO-TIMER feature offers a unique selection of multiple choice,

AUTO TIMER

fully automatic on and/or off (start/stop) programs between 1-12 hrs
under any one mode of your Home Comfort Unit.
The programs are as follows:
a) Auto-Off: Pre-select a time that will turn off the unit automatically (between 1-12hrs).
b) Auto-On: Pre-select a time that will turn on the unit automatically (between 1-12hrs).
c) Auto-On & Auto Off: Pre-select a time that will turn the unit ON / OFF automatically at
specified times (between 1-12hrs).
Note: These functions must be performed daily, as the program is automatically
canceled/erased after the program has ended.
CLOCK TIMER
a) Press CLOCK button, LCD clock display flashes. Press UP or DOWN: for every second
held, the LCD clock display changes setting by 1 min. intervals.
b) Press (UP) or
changes setting by 30 min. intervals.
c) When setting is complete, press the CLOCK button again to confirm the setting. LCD will
stop displaying CLOCK and will display the set time.
WATER TANK
FULL INDICATOR
After discharging water from the tank (See "Draining Excess
Water" on pg. 5 ), please press the POWER ON/OFF button to
operate the unit. The unit will continue to operate in the mode that
was operating before emptying the tank.
FILTER CLEANING
INDICATOR
A signal is given after approximately 650 hours of operation in
order to prevent you from forgetting to replace the filter. A light on
the front of the device will illuminate (Fig. X). The indicator light
will be displayed ONLY when in running mode.
DEFAULT INDICATOR
When default indicator lights are illuminated, this indicates internal wiring failure.
If you see the above two failure lights, please contact your qualified service technician.
(DOWN) and hold for more than 1 second. The LCD clock display
When the water tank is full, the RED LED indicator flashes (Fig. W)
and the unit stops running.
10
www.sylvane.com (800) 934-9194
Fig. W
Fig. X