Lorex L19WD800 Series Instruction Manual page 34

Using the System
RS-232C
Adjust settings for an external
communication device.
• BAUDRATE– Transmission speed between
the system and the device.
• LENGTH – The length of the transmission
signal.
• STOP BIT– Bit that indicates that a piece of
information has just been transmitted.
• PARITY – Can help detect errors in
transmission.
• FLOW CONTROL– Assign control of signal
transmission to hardware or software.
Click OK to save your settings, or click
DEFAULT to restore factory defaults.
34
REMOTE CONTROL
Set the remote control up to six units of the
L19WD series.
To assign remote control functionality:
1. From the Remote Control drop-down
menu, select ALL to control up to six
systems simultaneously.
OR
1. Select 1-6 to assign a specific
L19WD series unit to the remote
control.
2. Press the corresponding button on
the remote control (DVR1 – DVR6) to
control only that specific system.
Click OK to save your settings, or click
DEFAULT to restore factory defaults.
Note: If you select 01 in the Remote Control
settings, you must press DVR1 on the remote
control to operate the system.