Table of Contents
Advertisement
CE-Series Amps with an Attitude!
2.6.4b—If the Mode switch is in the "Bridge" position (for
mono configuration), connect the load across the positive
(+) terminals of the connector as shown in Figure 2.8. Re-
fer to Figure 2.11 for complete system setup. For Bridge-
Mono Mode, non-inverting output, Ch1+ is the positive
(+) and Ch2+ is the negative (–).
2.6.4c—Never short or parallel the output channels of a
CE-Series amplifier to itself or any other amplifier.
2.6.5—Slide the connector insert (B) into the connector hous-
ing (A), making sure that the large notch on the outer
edge of the insert lines up with the large groove on the
inside of the connector housing. The insert should slide
easily through the housing and out the other side until it
extends approximately
the housing (see Figure 2.9).
3
/
-inch (19-mm) from the end of
4
Fig. 2.8
Bridge-Mono
Output Wiring
Fig. 2.9
Detailed Neutrik
Speakon NL4FC
Connector
Assembly: Insert
into Connector
Housing
Page 19
Hide quick links:
Advertisement
Table of Contents
