ProForm 415 CT User Manual page 11

11. IMPORTANT: To avoid damaging the
Crossbar (107), do not use power tools and
do not overtighten the #10 x 3/4" Screws (2).
Orient the Crossbar (107) as shown. Attach the
Crossbar to the Handrails (82, 83) with four #10
x 3/4" Screws (2) and four #10 Star Washers
(12); do not tighten the Screws yet.
Insert the Console Frame (102) into the
Handrails (82, 83). Attach the Console Frame
with four 1/4" x 1" Screws (9); do not tighten
the Screws yet. Be careful not to pinch the
Upright Wire (87).
Tighten the indicated #10 x 3/4" Screw (2) in
each end of the Crossbar (107); do not over-
tighten the Screws. Then, tighten the other #10
x 3/4" Screw (2) in each end of the Crossbar.
Tighten the four 1/4" x 1" Screws (9).
12. Firmly tighten the two 5/16" x 1" Bolts (4) and
the four 5/16" x 1" Flat Head Screws (14) (only
one side is shown).
With the help of a second person, hold the con-
sole assembly near the Right Handrail (83) and
the Left Handrail (not shown).
Connect the Upright Wire (87) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
Connect the ground wire from the console as-
sembly to the Console Ground Wire (52).
11
First
9
2
12
107
82
12
Console
Assembly
Console
Wire
87
Wire
Tie
4
14
11
102
First
2
9
12
87
83
Console
Wire
87
Ground Wire
52
83