Pro-Form 385ex User Manual page 6

3. With the help of a second person, hold the Console Base
(6) and the other Handrail (2) near the right Upright (14)
as shown. Insert the Wire Harness (26) down into the right
Upright; bend the Wire Harness, if necessary. Next, route
the Wire Harness through the bracket on the Handrail and
insert the bracket into the right Upright. Make sure that
the Wire Harness is not pinched.
4. Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the right Upright (14) and the right Handrail (2). Do
not tighten the Handrail Bolt yet.
Make sure that the hole in the bracket on the Extension
Leg (41) is aligned with the hole in the Handrail (2).
Tighten an Extension Leg Screw (34) into the bracket and
Handrail.
5. Attach the Console Base (6) to the Handrails (2) with four
3/4Ó Screws (59).
Tighten all parts used in steps 2, 4, and 5.
6. Remove the backing from the Adhesive Clip (74). Press
the Adhesive Clip onto the base of the Uprights (14) in
the indicated location. Press the Allen Wrench (73) into
the Adhesive Clip.
7. Attach the Storage Latch (12) to the left Upright (14) with
two 1/2Ó Screws (13). Be careful not to overtighten the
Screws.
8. Make sure that all parts are tight before you use the
treadmill. (Note: The ratchet screws shown at the far
right are factory set and should not be adjusted.) To
protect the floor or carpet from damage, place a mat
under the treadmill.
3
Bracket
2
4
5
2
6
7
14
12
6
6
26
14
15
16
2
14
34
Bracket
41
6
59
2
74
8
Ratchet
Screws
13
59
14
73