Information; Setup - Runco RS-900 Owner's Operating Manual

Select Information from the Main Menu to see projector status information: the
currently-active source, input signal resolution, aspect ratio, picture memory and lamp
usage. This menu also displays the projector serial number.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
You can also press INFO on the RS-900 remote control unit (Figure
2-4) to display this information.
To access advanced projector settings, use the up- or down-arrow keys to highlight
Setup and press ENTER. Use the number buttons on the remote to enter the Setup
menu passcode when prompted and press ENTER again. Then, press MENU on the
remote control.
You only need to enter the Setup menu passcode the first time you
Note
select that menu after turning on the projector.
Lamp Power: Select Lamp Power from the Setup Menu to adjust the lamp output level.
You can choose to run the lamp as bright as possible (200W; this is the default setting) or
you can choose the lower (170W) setting. Generally, lower lamp output prolongs the life of
the lamp, but decreases brightness.
Lamp Hours: When you replace the projector lamp (refer to Lamp Replacement on
page 65), you should also reset the lamp timer. To do this, select Lamp Hours from the
Setup menu. Press the right-arrow key on the remote to highlight "Yes," then press
ENTER to confirm the reset.
Reset the Lamp Timer ONLY after you replace the lamp. Otherwise,
Note
the reported "Lamp Hours" will be inaccurate.
Do not exceed the recommended lamp life of 2000 hours. An old
WARNING
lamp becomes increasingly fragile and prone to sudden failure.
Runco RS-900 Owner's Operating Manual 59
Operation

Information

Information
Source HDMI 1
Resolution 1920x1080
Aspect Ratio
Picture Memory ISF Night
Lamp Hours
Serial RUP900RS0735001

Setup

Setup
Lamp Power 200 Watts
Lamp Hours
Fan Mode Normal
Background Color Black
PIP
RVR
12-volt Trigger Normal
V. Correction
Amplitude
Auto Off
Default
16:9
450
>
Off
0
0
>
0