Installation/Removing The Unit - Kenwood KDC-X592 Instruction Manual

Installation/Removing the Unit
non-Japanese cars Removing the hard rubber frame
Metal mounting strap
(commercially available)
Firewall or metal support
\
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
Self-tapping screw
(commercially available)
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory@
Removal tool
2
When the upper level is removed, remove the
lower two locations.
~
~
• The frame can be removed from the bottom side in the
same manner.
~
• Be careful to avoid injury from the catch pins on the
removal tool.
S
Pull the unit all the way out with your hands, being
careful not to drop it.
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Remove the screw (M4 x 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
4
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
Screw (M4
x
8 mm)
(commercially available)
/ Accessory@
f'il...".
ars
ars
r-
T@
+-
@N
@
@T
I
TIN
N
' -
/1
T:Toyota c
N: Nissan c
a~8mm
MAX.
j~,mm
MAX.
H @
1----l0
05mm
05mm
Accessory@...for Nissan car
Accessory0 ...for Toyota car
Screw (M4
x
8 mm)
(commercially available)
Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
~
Japanese cars
~
~
English
I
27