Installation/Removing The Unit - Kenwood KDC-BT838U Instruction Manual

Installation/Removing the Unit
non-Japanese cars
Removing the hard rubber frame
Metal mounting strap
(commercially available)
Firewall or metal support
\
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
Self-tapping screw
(commercially available)
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
AccessorY0
Removal tool
2
When the upper level is removed, remove the
lower two locations.
Q
~
• The frame can be removed from the bottom side in the
same manner.
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Remove the screw (M4 x 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
4
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
Screw (M4 x 8 mm)
(commercially available)
/ Accessory0
~,
~
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands, being
careful not to drop it.
Removing the Unit
ars
ars
,....
+-
T@
@N
@ @
!T/N
N
T
" -
/1
T: Toyota c
N: Nissan c
B~8mm
MAX.
W~8mm
MAX.
1----1
0
I----l®
0Smm
0Smm
Accessory0...for Nissan car
Accessory®...for Toyota car
Screw (M4
x
8 mm)
(commercially available)
Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
~
Japanese cars
~
~
English
I
37