Opening And Closing Looper Cover And Work Support - Pfaff hobbylock 4760 Instruction Manual

Opening and closing looper
cover and work support
Push looper cover 10 fully to the right.
hold it, and swing it down.
To close the looper cover, push it up
until it locks.
To open work support 12, push it in
the direction indicated by the arrow. To
close the work support, push it lightly
until it locks.
Behind the looper cover converter 41 is
illustrated with its slide settings for the
respective stitch type. On the inside of
the looper cover the individual threa
ding paths are illustrated in colors.
Important!
While the looper cover or work support
is open, power supply to the machine is
interrupted.
Threading of guide wires 18 and 22
Place thread spools on thread spool
stands. The machine must be threa
ded correctly. First pull the threads
through guides 18 according to colors.
Then lift carrying handle 2 and place
the thread in rear guides 22. Set the
thread tensions at N and thread the
machine in the following sequence:
1. right looper (yellow)
2. left looper (red)
3. right needle (green)
4. left needle (blue)
Push carrying handle 2 down again.
9