Power Nozzles; Replacing Belt; The Belt - Hoover Vacuum Systems Owner's Manual

3-5
D

Power nozzles

Carpet or rug cleaning
When using the nozzle for carpet and ru g
cleaning, push the Floor Surface Switch (D)
on hand grip toward " RU G " . This setting
p rovides the agitator action n e c e s s a ry to
deep clean carpets. The nozzle adjusts
automatically to various carpet pile heights.
3-7
It is, there f o re, necessary to a lw ay s
unplug the hose power cord from the
electrical outlet when cleaning is fin-
i s h e d .
4-1
On the PowerMAX™ nozzle, the belt is visi-
ble through the belt check window (A) on
top of the nozzle. If the belt is broken, the
motor pulley will be visible through the win-
d o w.
6
H a rd surface floor cleaning
The nozzle can be used for cleaning hard
s u rface floors such as wood, linoleum,
vinyl, asphalt and rubber tile, sealed cork,
c o n c rete and terrazzo, as well as carpet.
To set the power nozzle for hard surf a c e
floor cleaning, push the Floor Surf a c e
Switch (D) toward " BA R E ". This setting
p rovides no agitator action. If you pre f e r,
you may use the wall/floor brush to clean
b a re floors.
4. Maintenance
Familiarize yourself with these home main-
tenance tasks as proper use and care of
your cleaner will ensure continued clean-
ing eff e c t i v e n e s s .
S t a n d a rd and
PowerMAX™ power
n o z z l e s

The belt

The belt in your power nozzle drives the
a g i t a t o r. It has been designed specifically
for use in this cleaner and is important for
e ffective operation.
4-2
A
How to re p l a c e
Disconnect hose power cord from elec-
trical outlet and disconnect power noz-
zle from extension wands.
Tu rn nozzle over and unscrew the 4
recessed Phillips head scre w s .
N o t e : Do not remove the 3 screws in the
triangle formation as these hold the
motor in place.
3-6
E
Note: The headlight (E) on the 'PowerMAX'
nozzle remains ON as long as the hose
power cord is plugged into an electrical
o u t l e t .
What to buy
Use only a genuine HOOVER B e l t N o .
4 0 2 0 1 0 4 5 when a belt replacement is nec-
e s s a ry.
When to re p l a c e
T
he belt should be checked from time to
time to be sure it is in good condition. To
check, remove the nozzle cover (see fol-
lowing section). Replace the belt if it is
s t retched, cut, or bro k e n .
4-3
R e t u rn nozzle to original position, lift off
nozzle cover.