Kenmore 795.6900 Series Service Manual page 21

With a flat-head screwdriver, carefully pry off and
remove the cover over the screw holes on the left side
of refrigerator housing.
Fig. 90
Remove the 2 outer screws from cabinet frame as
shown.
You will need these holes for the Middle Hinge Bracket.
Fig. 91
Place screws into outer holes on right side of cabinet.
Attach cover on the right side. Cover is force-fitted.
Fig. 92
Flip the middle hinge bracket and position on
left side of refrigerator and re-attach with
two bolts and a 2 phillips screws.
Fig. 93
Using a 13/32" or 10mm socket wrench with
2" extension, loosen the 2 bolts and remove
bottom hinge from right side.
Bottom Hinge Pin
Bottom Hinge
Bracket
Remove the bolt on bottom of refrigerator from
the left side and insert it on the right side.
You will need this hole for the Bottom Hinge.
Fig. 95
Left Side Right Side
Move the Bottom Hinge to the left side keeping
the same orientation and attach 2 bolts.
Fig. 96
Change the Hinge Pin from the right side to left side.
Before
- 21 -
Fig. 94
After
Fig. 97