Reverse Swing Refrigerator And Freezer Doors - Kenmore 795.6900 Series Service Manual

3-8-3 REVERSE SWING REFRIGERATOR
AND FREEZER DOORS
screwdriver and remove.
Fig. 77
Using 10mm or 13/32-inch socket wrench, remove
the 3 bolts and lift off the T op Hinge. Set parts aside.
Fig. 18
Fig. 78
Lift up refrigerator door slightly and remove it.
Fig. 79
Hinge Pin
Remove Hinge Pin Insert on the right side of the
door and reinstall on left side of door.
Fig. 80
Hinge Pin
Insert
Turn refrigerator door upside down on a non-scratch
surface.
Loosen the 2 screws to remove the Bottom Hinge
Pin Insert Bracket with Hinge Pin Insert.
Fig. 81
Hinge Pin
Insert Bracket
Remove the screw on the opposite side of the door.
This screw is no longer necessary and can be
discarted.
Move the Hinge Pin Insert Bracket to the other side
of the door, keeping the same orientation, and push
the Hinge Pin Insert into the hole on the left side of
the bracket. Insert the 2 screws as shown below.
Fig. 82
uncover screw holes and place ir on the right side.
Fig. 83
- 19 -
Hinge Pin
Insert