Selecting A Camera Group - Panasonic AW-RP120G Operating Instructions Manual

Selecting a camera group

This unit allows you to register up to 100 remote cameras as control
targets by configuring the connection settings for each of the camera
numbers CAM1 to CAM100. To select a remote camera to control from
these cameras, you need to select the camera group to which it belongs
beforehand.
Camera
Camera numbers
group
1 CAM1 to CAM10
2 CAM11 to CAM20
3 CAM21 to CAM30
4 CAM31 to CAM40
5 CAM41 to CAM50
Selecting a camera group
1.
Press the selection mode button [SELECT] to turn off
the button indicator.
2.
Press a camera selection button [CAMERA SELECT/
GROUP SELECT] to select the camera group to which
the remote camera you want to control belongs.
When a camera group is selected, the corresponding camera group
indicator [CAMERA GROUP] lights green.
Example: When camera group 10 is selected
Note
z It takes about 5 seconds in the case of IP connections and
z
up to about 20 seconds in the case of serial connections for
operation to become possible after switching camera groups.
(When AW-HE50, AW-HE60 and AW-HE120 are connected,
and they are all powered on.)
Camera
Camera numbers
group
6 CAM51 to CAM60
7 CAM61 to CAM70
8 CAM71 to CAM80
9 CAM81 to CAM90
10 CAM91 to CAM100
1
2
37