Bluetooth; Connect Microphone; Pairing - Kenwood KDC-BT358U Instruction Manual

BLUETOOTH®
You can operate Bluetooth devices using this unit.
Connect the microphone
Rear panel
Microphone input jack
Adjust the
microphone angle
Secure using cord clamps (not
supplied) if necessary.
If you turn off the unit or detach the control panel
during a phone call conversation, the Bluetooth
connection is disconnected. Continue the
conversation using your mobile phone.
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
– Object Push Profile (OPP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
10
Pair a Bluetooth device
When connecting a Bluetooth device to the unit for the first time, perform pairing between the
unit and the device. Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit.
Microphone
• Up to five devices can be registered (paired) in total.
(supplied)
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at
any time.
• This unit supports Secure Simple Pairing (SSP).
• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect the
device to the unit manually. Refer to the instruction manual of the Bluetooth device for more
information.
Press B SRC to turn on the unit.
1
2
Search and select this unit model name (KDC-BT3**U) on the Bluetooth device.
"PAIRING" "PASS XXXXXX" Device name "PRESS" "VOLUME KNOB" scrolls on the
display.
3
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed and "BT" will light up when the Bluetooth
connection is established.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
• Pairing request (via Bluetooth) is automatically activated if an iPhone/iPod touch is connected
through the USB input terminal. (Applicable only if [AUTO PAIRING] is set to [ON].) ( 14)
Press the volume knob to pair once you have confirm the device name.
Bluetooth test mode
You can check the connectivity of the supported profile between the Bluetooth device and the
unit.
• Make sure there is no Bluetooth device connected.
1
Press and hold
"PLEASE PAIR YOUR PHONE" appears.
2
Search and select this unit model name (KDC-BT3**U) on the Bluetooth device.
3
Operate the Bluetooth device to confirm pairing.
"TESTING" flashes on the display.
.