Sharp XV-Z1A Service Manual page 12

XV-Z1E/A
4. Removing the PWBs
4-1. Remove the two screws that fix the PC terminal cover to the bottom cabinet.
4-2. Remove the two screws off the output shield. Take out the output shield and disconnect the R-LCD, G-LCD
and B-LCD connectors (RP, GP, and BP).
4-3. Remove the four screws off the output unit. Disconnect the insulating barrier, the ground leads and the
connectors (FN, Q, LL, FF, LF, BL, RC and EA). Pull up and away the output unit and the signal/Video Input
terminal unit.
4-4. Remove the screw off the back of the output unit. Separate this unit from the signal/PC terminal unit.
4-5. Remove the screw off the bottom cabinet and the screw off the power panel. Now take out the power panel.
Insulating
Barrier
Output Unit
4-4
Signal/Video Input
terminal Unit
4-3
4-3
4-2
4-1
Video Input Terminal Cover
12
Output Shield
Power Panel
4-5
4-1 4-1