D-Link AirPremier DWL-3200AP User Manual page 32

DWL-300AP User's Manual
Security:
VLAN Tag Mode:
Ethernet Without Tag:
When Primary SSID is set to any of
the following security levels:
None
Open System (WEP)
Shared Key (WEP)
WPA-Personal
WPA-Personal
WPA-Auto-Personal
WPA-Enterprise
WPA-Enterprise
WPA-Auto-Enterprise
Note: If WPA or WPA is being used, it will occupy the key space  and 3, which will
leave key 1 and 4 for other SSIDs to use for WEP.
When you configure one Multi-SSID, you must click Save to Table and then click
Apply to save your settings.
D-Link Systems, Inc.
The Multi-SSIDs security can be WPA/WPA-Enterprise or WPA-
Auto-Enterprise only when the Primary SSID's security is at the
same security level. Also, they must connect to the same RADIUS
server.
Select Manual or Dynamic. You can input the VID manually, or
configure as dynamic, station can get specific VLAN Tag from
RADIUS server to work with VLAN supported switches or other
devices when the Primary SSID's security is set to WPA-Enterprise,
WPA-Enterprise, WPA-Auto-Enterprise.
This will cause the access point to send DHCP requests with the
VLAN tag. The switch and the DHCP server must support VLAN
IEEE80.1Q frames. The access point must be able to reach the
DHCP server.
Check with the Administrator regarding the VLAN and DHCP
configurations.
You can enable this function to untag the packets from wireless to
Ethernet if VLAN is enabled.
Priority:
Specific the 0-7 priority queue when priority is enabled
WMM:
Select Enable or Disable.
Multi-SSID can use any of these
security levels:
None
Open System (WEP)
Shared Key (WEP)
WPA-Personal
WPA-Personal
WPA-Auto-Personal
None
Open System (WEP)
Shared Key (WEP)
WPA-Personal
WPA-Personal
WPA-Auto-Personal
WPA-Enterprise
WPA-Enterprise
WPA-Auto-Enterprise
3