Dhcp Server Settings - D-Link DIR-600L User Manual

Section 3 - Configuration
DHCP stands for Dynamic Host Control Protocol. The DHCP
Server (built-in to the router) will automatically assign an IP
address to the computers and devices on your network. Be
sure to set your computers to be DHCP clients by setting
their TCP/IP settings to "Obtain an IP Address Automatically. "
When you turn your computers on, they will automatically
load the proper TCP/IP settings provided by the DIR-600L.
The DHCP Server will automatically allocate an unused
IP address from the IP address pool to the requesting
computer. You must specify the starting and ending address
of the IP address pool.
Enable DHCP
Check the box to enable the DHCP server on your
Server: router. Uncheck to disable this function.
DHCP IP Enter the starting and ending IP addresses for the
Address Range: DHCP server's IP assignment.
Note: If you statically (manually) assign IP addresses to
your computers or devices, make sure the IP addresses
are outside of this range or you may have an IP conflict.
DHCP Lease The length of time for the IP address lease. Enter the
Time: Lease time in minutes (default setting is 1440).
DHCP Client List:
Displays the name, IP address, MAC Address, and lease
time of devices currently assigned IP settings by the
router.
Avoid ARP Check to defend against ARP spoofing (ARP poison
Attack: routing) attacks to your local network.
D-Link DIR-600L User Manual

DHCP Server Settings

28