Eeprom Writing-In Completion Ok/Ng Screen; Hposi Screen; While In Mecha Adjust Process - Kenwood DDX6019 Service Manual

DDX6019/6029/6029Y/6039

EEPROM writing-in completion OK/NG screen

Key specification
Return: Move on to Test Mode Main screen.
Note: If NG, go into the test mode again and repeat from
the 1st step.

Hposi screen

• Adjust each screen's horizontal display position (refer to the
separate sheet for more detail).
Each Hposi adjustment screen
< <
< <
Key specification
Next: To the next Hposi adjustment screen, or when in NAVI
screen, start EEPROM writing.
<<: Screen moves toward the left.
>>: Screen moves toward the right.
Cancel: Move on to Test Mode Main screen.
Note: The top row of the first adjustment screen (Graphic)
does not need to be adjusted.
26
TEST MODE
Return
Write OK/NG
Next
Adjustment item
> >
Step value
Adjustment item
> >
Step value
Cancel
EEPROM writing-in completion OK/NG screen
Hposi OK/NG
Key specification
Return: Move on to Test Mode Main screen.
Note: If NG, go into the test mode again and repeat from
the 1st step.
MECHA ADJ screen
• After installing the mechanism position adjustment jig, ad-
just the panel mechanism position.
MECHA ADJ screen
MECHA Adjust
Full Close AD : H
Full Open AD : H
Key specification
MECHA Adjust: Start mechanism position adjustment.
1: Set the mechanism position (Tilt) to "1".
Return: Move on to Test Mode Main screen.

While in MECHA Adjust process

MECHA Adjust
Mecha Adjusting
Return
1
Return
1
Return