Step 9 Mount The Thermostat; Check Thermostat Operation - Honeywell MAGICSTAT CT2400 Programming And Installation Instructions

A. ENGAGE TABS AT TOP OF
THERMOSTAT AND MOUNTING PLATE.
NOTE: To remove thermostat from wall, first pull out at
bottom of thermostat, removing top last. *4

Check Thermostat Operation

Programming And Installing
HEATING
Do not check heating system
operation by jumpering thermostat
terminals at the primary control such
as the gas valve, zone valve,or oil
burner control. This will damage the
thermostat. Instead, jumper R and W
wires at the thermostat.
c.
B.
PRESS LOWER EDGE
OF CASE TO blTCH.
1
After
Move the system switch to HEAT and
the fan switch to AUTO.
Temp
Press key until the setting is about
10° F [6° C] above room tempera-
Warmer
ture. Heating should start and the fan
c 1
should run after a short delay
(immediately if fan operation switch is
set in E position).
Temp
Press key until setting is about 10° F
[6° C] below room temperature. The
Cooler
heating equipment should shut off.
25