Honeywell MAGICSTAT CT2400 Programming And Installation Instructions page 6

Weekdays
WAKE
RETURN
SLEEP
WAKE
SLEEP
the weekend schedule.
NOTE: If you decide not to program the thermostat, it will automatically control heating at
68° F [20° C], and cooling at 78° F [26° C], 24 hours a day.
——-
This guide can be used for programming your new thermostat.
NOTE: Batteries are required for operation and programming. When inserting batteries, set
system switch to OFF. Remove battery door (on thermostat left side) using a coin at the
bottom. Follow instructions on pages 6 and 7.
Set Current Time/Day
To set time, press and release ~kwma~ once,
Heating Program
With system switch at HEAT, press and release ~~uk once. "WAKE," Mon-Fri and "SET"
appear on display.
Time
Ahead
c 1
to program "WAKE time and
Use
Back
Mon-Fri. Repeat sequence for "LEAVE," "RETURN," "SLEEP."
Press ~C~~Ub until "WAKE," "SA SU" and "SET" appear on display. Use
c 1
Temp
u
—
Warmer
"WAKE" time and ,—, to program "WAKE temperature for Sat-Sun. Repeat sequence
u
Cooler
for "SLEEP."
Cooling Program
With system switch at COOL, follow the same instructions as for Heating Program.
After programming, adjust fan and system switches as desired. Press and release
start the program.
COOLING PROGRAM
Start Time
Cooling Ternperature~
0
C] or any lower than 45° F [7° C]
11
T i m e
Ahead
until current time shows; to set day,
Back
Time
until current day shows; then
Back
c 1
12
Temp
Warmer
to program "WAKE" temperature for
Cooler
13
—
press
Time
Ahead
to program
Back
to