Connecting Your Digital Terrestrial Receiver To Other Equipment - Philips DTR 230 User Manual

DSR220co.book Page 11 Lundi, 18. janvier 2010 6:23 18
Note that the only recommended way to disconnect the Digital Terrestrial Receiver from the
mains supply is to remove the adaptor from the mains socket. If the mains socket is fitted with a
switch, this could be used instead.
Receiver rear panel
3.5

Connecting your Digital Terrestrial Receiver to other equipment

The following diagrams are of typical configurations only, and may differ slightly to your existing
external equipment. If you are unsure on how to connect to your receiver, always consult your
manufacturer's user guide supplied with your equipment.
Connecting to a television and DVD player
UHF
antenna
Receiver rear panel
If you decide to connect a DVD player or recorder to the VCR Scart of your digital receiver, we
advise to set the DVD output format to CVBS or PAL.
Refer to the user manual of your DVD player or recorder. You can use a S/Pdif connector to
connect your Receiver to a digital sound input device, such as a receiver.
Getting Started
SCART input on TV
RF Out RF In
connector connector
SCART to DVD player
+12V DC
Power supply adaptor
To 230V AC
mains supply
TV set - rear
SCART output
to TV
DVD player - rear
Receiver
11