Error Status - Epson Stylus Photo R800 Service Manual

EPSON Stylus Photo R800

1.3.6 Error Status

If any of the following states is detected, this printer is put in an error status and
turns the interface signal -ERROR "Low" and BUSY "High" to inhibit data input.
At this time, the printer is automatically disabled from printing. However, when
communication is being made using the IEEE1284.4 protocol, communication
with the printer is enabled.
General error
After the cause of this type of error is removed, the printer can resume its
operation from where it stopped due to the error
Table 1-5. General error
Error Status Occurring Condition
Paper Mismatch If the paper path specified by the
Error print data is different from the
printer's real paper path, the printer
goes to this error.
Paper Out When printer fails to load a sheet, it
goes Paper Out Error.
Ink Out When the printer runs out the most
part of the ink of any one color, it
warns Ink Low and keeps printing.
When the printer runs out the whole
ink of any one color, it stops printing
and indicates Ink Out Error. User is
requested to install a new Ink-
Cartridge in this state.
No Ink Cartridge/ When printer detects that Ink
CSIC Error Cartridge comes off, it goes this error
mode.
Paper Jam Error • Failure of ejecting a sheet
• Failure of loading a sheet to the
loading position
Card Loading When the card was loaded to the
Error wrong position, the printer goes this
error.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
PRODUCT DESCRIPTION
Error Status
Cutter Jam Error
Cover Open Error
Resuming Condition
Change the printer's
paper path to the one
specified by the data.
Error Status
Set the paper to the ASF
Fatal Error
and push the Paper
switch.
Install the new Ink
Cutter Position
Cartridge.
Error
Maintenance
Request
Install the new Ink
Cartridge.
Remove the jammed
paper.
Set an A4 paper to the
ASF, and press the
Paper switch. If the card
couldn't eject at your first
try, repeat again the
same method.
Functions
Table 1-5. General error
Occurring Condition
When Cutter can't cut the paper, it
goes Cutter Jam Error.
When the cover is opened at
Economy printing mode, the printer
goes this error.
Fatal error
After the cause of this type of error is removed, the printer cannot return to
normal unless it is powered off and then on again
Table 1-6. Fatal error
Occurring Condition
When detecting a Fatal Error such as
a carriage control error, the printer is
placed in an error status.
When Cutter can't return to cutter
home position, it goes Cutter Position
Error.
When the total quantity of ink wasted
through the cleaning and flushing is
reaches to the limit, printer indicates
this error and stops.
Revision A
Resuming Condition
Switch power off and
recheck the cutter state.
When a paper jam has
occurred, clear the
paper.
Close the cover.
Resuming Condition
Turn off and turn on.
Switch power off and
recheck the cutter state.
When a paper jam has
occurred, clear the
paper.
Replace the Waste Ink
Pads in the printer
enclosure by a service
person.
13