Functions Of The Control Panel - Daewoo DWF-760 Service Manual

3. FUNCTIONS OF THE CONTROL PANEL

Control panel has micom sensor.
As the buttons are pressed, the lamps indicating the selection of your desired washing program will light up.
RES.
CONTROL
ONLY SPIN
PROGRAM
NOTES
• If you open the Door(Lid) When wash and rinse processing, the PULSATOR is not working with
"LE" signal on the PCB and Buzzer alarm.
• And if close the Door(Lid), the remain process will be done continuously.
4 CONTROL PANEL
• Press this switch to turn the power on or off.
• It can be used to choose water temperature to be supplied.
• As the button is pressed, water temperature will be repeated.
COLD COLD+HOT HOT
• In case of the single valve model, there is no wash temperature selector function.
• It can be used to adjust amount of water according to the size of the load to be
washed.
• As the button is pressed, water level is selected by
MID HIGH LOW
• It can be used to pre-engage time for wash.
• It is the button for the partial process or the combination of each process (wash, rinse,
spin)
• If you want to change wash time, rinse times, spin time, you must press this button
after selection each process by the process button.
Also, this button can be used to spin only.
• It can be used to select the full-automatic program.
• As the button is pressed, program will be selected by following order:
FUZZY FUZZY+SOAK
• Operation and temporary stop is repeated as it is pressed.
• When you want to change program in operation;
press the "START/HOLD" button
press the "START/HOLD" button again.
ONLY SPIN
HEAVY HEAVY+SOAK
Select the program that you want to change
DWF-760M
SPEEDY SUIT(WOOL)