3. FUNCTIONS OF THE CONTROL PANEL
Control panel has micom sensor.
As the buttons are pressed, the lamps indicating the selection of your desired washing program will light up.
• Press this switch to turn the power on or off.
• It can be used to choose water temperature to be supplied.
• As the button is pressed, water temperature will be repeated.
• In case of the single valve model, there is no wash temperature selector function.
• It can be used to adjust amount of water according to the size of the load to be washed.
• As the button is pressed, water level is selected by MID → HIGH → LOW
RES.
• It can be used to pre-engage time for wash.
• It is the button for the partial process or the combination of each process (wash, rinse,
• If you want to change wash time, rinse times, spin time, you must press this button after
CONTROL
• It can be used to select the full-automatic program.
• As the button is pressed, program will be selected by following order :
PROGRAM
• Operation and temporary stop is repeated as it is pressed.
• When you want to change program in operating;
4
CONTROL PANEL
RES.
→ COLD+HOT → HOT
COLD
spin) (See page 7)
selecting each process by the process button. Also, this button can be used to spin only.
(See page 7)
FUZZY → FUZZY+SOAK → HEAVY → HEAVY+SOAK → SPEEDY → SUIT(WOOL)
press the "START/HOLD" button → Select the program that you want to change → press
the "START/HOLD" button again.
HOURS
PROGRAM
CONTROL