Kenwood DNN990HD Quick Start Manual page 32

Quick Start Guide
Connecting wires to terminals (2)
DNN990HD
iPod/
AV-IN/OUT AV-IN2 MIC
AV-OUT
AUDIO
R L
Ignition key
switch
Car fuse box
(Main fuse)
Battery
To use the steering wheel remote control
feature, you need an exclusive remote adapter
(not supplied) matched to your car.
To car light control switch
Connect to the terminal that is grounded
when either the telephone rings or during
To use the Mute feature, you need to hook
up this wire to your telephone by using a
commercial telephone accessory.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
of the film-type antenna. (Max. 300mA, 12V)
When using the optional power amplifier,
connect to its power control terminal.
If no connections are made,
do not let the cable come out from the tab.
M4 x 8mmMAX
GPS
iDalalink I/F
PTT
POWER
EXT
I/F
ACC
Red (Ignition wire)
Yellow (Battery wire)
Car fuse box
Black (Ground wire) ¤
(To car chassis)
A
A
Light Blue/Yellow
(Steering remote control wire)
To steering remote
Brown (Mute control wire)
conversation.
booster amplifier
EN
DNN770HD
GPS M4 x 8mmMAX
iPod/
MIC
AV-IN AV-IN2
VIDEO
AV-OUT
AUDIO
EXT
I/F
R L
Accessory 1
White/Black
Green/Black
REMOTE STEERING
CONT WHEEL
REMOTE
INPUT
Orange/White
Purple/Black
(Dimmer control wire)
ILLUMI
MUTE
Blue
(Antenna control wire)
ANT CONT
Blue/White
(Power control wire)
P. CONT
32
iDalalink I/F
POWER
Speaker impedance: 4-8 Ω
To front left
speaker
+
White
Gray/Black
To front right
speaker
+
Gray
To rear left
speaker
+
Green
To rear right
speaker
+
Purple