Kenwood DNN990HD Quick Start Manual page 27

Installation Procedure
Supplied accessories
First of all, make sure that all
accessories are supplied with the
unit.
1 ...1 8 ...1
2 ...1 9 ...1
3 ...2
0...1
4 ...1 - ...1
5 ...1
= *
6 ...6
~ *
7 ...6
*
1
(3.5 m)
(3 m)
...1
1
(3 m)
...1
1
DNN990HD only
27
EN
DNN990HD/ DNN770HD
Unit
1 To prevent a short circuit, remove
the key from the ignition and
disconnect the ¤ terminal of the
battery.
2 Make the proper input and
output wire connections for each
unit.
3 Connect the speaker wires of the
wiring harness.
4 Connect the wiring harness wires
in the following order;
ground, battery, ignition.
5 Connect the wiring harness
connector to the unit.
6 Install the unit in your car.
7 Reconnect the ¤ terminal of the
battery.
8 Press the <Reset> button.
(P.4)
9 Perform the Initial Setup.
See First Step (P.7).
● Non-Japanese cars
Bend the tabs of the
mounting sleeve
with a screwdriver
or similar utensil and
attach it in place.
Continued