Table of Contents
Advertisement
SPECIFICATIONS
Temperature Measurement
Main unit
Indoor Temperature
Proposed operating range
Temperature resolution
Remote Sensor
Proposed operating range
with alkaline batteries
Proposed operating range
with lithium batteries
Temperature resolution
RF Transmission Frequency
Maximum number of Remote sensors
RF Transmission Range
Temperature sampling cycle
Calendar and Clock
12 hour display in hh : mm format
Date Format: Month – Day format
Day of week: User- selectable in 3 languages
(English, Spanish, French)
Dual 4-minute crescendo alarm with snooze
Pre-alarm for ice alert with programmable time intervals
Blue Backlight
Power
Main unit
: 2 x UM-3/ AA (1.5V) batteries
- alkaline are suggested (not included)
: AC/ DC Adapter
(AC120V, 60Hz-DC6.0V, 120mA).
Remote Sensor : 2 x UM-3/ AA (1.5V) batteries
- alkaline are suggested (not included)
17
Dimensions
Main unit
Remote sensor : 2.38"(L) x 4"(H) x 1" (D)
: -5°C to +50°C /
FCC STATEMENT
23°F to 122°F
This device complies with Part 15 of the FCC Rules.
: 0.1°C/ 0.2°F
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
: -20°C to + 70°C /
-4°F to 158°F
Warning: Changes or modification to this unit not expressly
approved by the party responsible for compliance could void
: - 38°F to 158°F
the user's authority to operate the equipment.
( -38.8 C° to 70°C)
: 0.1°C/ 0.2°F
NOTE: This equipment had been tested and found to comply
with the limits for a Class B Digital device, pursuant to
: 433 MHz
Part 15 of the FCC Rules. These limits are designed to
: 3
provide reasonable protection against harmful interference
: Maximum 100 feet
in a residential installation. This equipment generates, uses
: approximately
and can radiate radio frequency energy and, if not installed and
45 seconds
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician
for help.
: 2.8"(L) x 7.09"(H) x 2.8"(D)
18
Advertisement
Table of Contents
