Table of Contents
Advertisement
AHE Series 4 Direct Vent Wall-Mounted Boilers — User's Information Manual
Operating instructions —
Honeywell VR8205 and White-Rodgers 36E gas valves
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance is equipped with an ignition
device which automatically lights the pilot.
try to light the pilot by hand.
not
B. Before
, smell all around the
OPERATING
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle on the floor. See below.
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use
any phone in your building.
1.
Read the safety information above on this label.
Stop!
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove control access panel.
5. This appliance is equipped with an ignition device which automatically
lights the burner. Do not try to light the burner by hand.
6. Turn
gas control knob
7. Wait five (5) minutes to clear out any gas. Then smell for gas, including
near the floor. If you smell gas,
above. If you don't smell gas, go to the next step.
8. Turn
gas control knob
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting.
11. If the appliance will not operate, follow the instructions
below and call your service technician or gas supplier.
To Appliance"
12. Replace control access panel.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Remove control access panel.
4. Turn
gas control knob
5. Replace control access panel.
10
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
Do
WHAT TO DO IF YOU SMELL GAS
OPERATING INSTRUCTIONS
clockwise
to
.
OFF
Follow
in the safety information
STOP!
"B"
counterclockwise
to
ON
TO TURN OFF GAS TO THE APPLIANCE
clockwise
to
. Do not force.
OFF
Robertshaw 7200 gas valve
C. Use only your hand to turn the gas control knob. Never use
tools. If the knob will not turn by hand, don't try to repair it,
call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control, which has been under water.
•
Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire department.
88731
White-Rodgers
36E Gas valve
Position indicator
(shown in "ON" position)
Honeywell
.
VR8205
Gas valve
"To Turn Off Gas
Position indicator
(shown in "ON" position)
Gas control knob
Gas control knob
Part number 550-141-893/0800
Hide quick links:
Advertisement
Table of Contents
