Table of Contents
Advertisement
INSTALLATION
1. Loosen the four torx screws located midway up the front of the housing leaving the
screws intact in the front portion. (Fig. 1)
2. Drill the mounting location, using the Drilling guide. (Fig. 3)
3. Attach the housing to the ceiling using suitable fasteners, M6x35 tapping screws are
supplied. Only use if they are suitable. (Fig. 3)
4. Close the housing using the loosen torx screws. (Fig. 2)
Figure 1
*Label is attached at the bottom.
Torx screws
M5x10 (4x)
Torx screws
M5x10 (4x)
7
Figure 2
Seal around
the housing
base tightly
using
Advertisement
Table of Contents
