Starting Warm Engine; Stopping Engine - Echo PB-770H Operator's Manual

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT
close the choke.
PB-770H
1. Throttle Lever
Move throttle position lever (A) to IDLE DETENT positions.
PB-770T
1. Throttle Position / Stop Switch Button
Slide Throttle position / Stop switch Button(A) back to idle
position.
PB-770H, PB-770T
2. Purge Bulb
Pump purge bulb (D) until fuel is visible. Pump bulb an additional
4 or 5 times.
3. Recoil Starter
Pull recoil starter handle (E) and engine should start. Do not use
choke (C).
NOTE
If engine does not start after 5 pulls, use cold start procedures.

STOPPING ENGINE

PB-770H
1. Throttle Lever
Move throttle lever (A) to IDLE DETENT position and allow
engine to return to idle before shutting off engine.
2. Throttle Lever
Move throttle lever (A) to "O" (Stop) position.
PB-770T
1. Throttle Position / Stop Switch Button
Release throttle trigger. Move Throttle Position / Stop Switch
Button (A) forward to idle position and allow engine to return to
idle before shutting off engine.
2. Throttle Position / Stop Switch Button
Move Throttle Position / Stop Switch Button (A) all the way
forward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
P B
OWER LOWER
O ' M
PERATOR S
PB-770H
A
PB-770T
C
E
D
PB-770H
A
PB-770T
A
17
ANUAL
A