Operation; Starting Cold Engine; Starting Warm Engine; Stopping Engine - Echo PB-2155 Operator's Manual

14
o
peraTIon
• Provide all operators of this equipment with the Operator's Manual
and instructions for safe operation.
IMPORTANT
Check unit for loose nuts, bolts and screws daily.
IMPORTANT
Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the
unit firmly.

sTarTIng Cold engIne

1. Move ignition switch to START/RUN position.
2. Move throttle lever to IDLE position.
3. Push purge bulb 3-4 times (or until fuel is visible in fuel return
line).
4. Close choke (move choke lever up) and pull starter handle until
engine fires.
5. Open choke and if necessary, restart engine.
NOTE
Allow engine to warm up before use.

sTarTIng warm engIne

1. Move throttle lever to IDLE position.
2. Move ignition switch to start, pull starter handle 1-3 times and
engine should start. Do not use choke.
NOTE
If engine does not start after 4 pulls, use cold start procedures.

sToppIng engIne

1. Release throttle trigger and allow engine to run at idle for a few
minutes.
2. Move throttle lever to IDLE position.
3. Move ignition switch to "STOP" position.
WARNING
If engine does not stop, shift choke lever to closed position.
Check and repair ignition switch before starting engine again or
serious personal injury may result.
DANGER
START/RUN
Throttle lever
Choke
Purge
lever
bulb
Ignition
switch
Throttle lever
Throttle trigger
Ignition
switch
Starter
handle
STOP