Starting Warm Engine; Stopping Engine - Echo PB-211 Operator's Manual

14
3. Place the blower on a flat clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope until engine
fires.
4. Push choke all the way in. (Open position)
Pull recoil starter handle/rope until engine starts and runs. Allow
unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in "Run" position after 4 pulls,
repeat instructions.
5. After engine warm up, gradually depress throttle trigger to
increase engine r/min to operating speed.

STARTING WARM ENGINE

1. Stop Switch - Start/Run.
Turn switch to "RUN" position.
2. Place the blower on a flat clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope until engine
fires.
IMPORTANT
Recoil starter: Use short pulls - only 1/2 - 2/3 of rope for starting.
Do not allow the rope to snap back in. Always hold the unit
firmly.
NOTE
If engine does not start after 4 pulls, use Cold Start Procedure.

STOPPING ENGINE

1. Release throttle trigger and allow engine to idle for a minute.
2. Move stop switch to "STOP" position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
DANGER
Recoil starter handle
Stop switch
Stop switch