Table of Contents
Advertisement
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions, except battery charging, will
be disabled.
To activate the CEC battery charging testing mode:
1.
Place all wireless microphone units (with batteries inserted) into the base unit to make sure they can
work normally with the base unit.
2.
Unplug the power cable from the power outlet.
3.
While you press and hold
4.
After about 20 seconds, when the base unit status indicators start flashing, release
then press it again within 1 second. After one minute, the base unit will enter the CEC battery
charging testing mode.
After about one minute, the base unit will enter the CEC battery charging testing mode. All wireless
microphone units are will be deregistered and the base unit status indicators will flash red.
If the base unit has failed to enter this mode, repeat Step 1 through Step 4 above.
Note: The base unit will be powered up as normal if you fail to press
To deactivate the CEC battery charging testing mode:
•
Unplug the power cable from the power outlet, and then plug it back in. The base unit is powered
up as normal. Insert batteries into your wireless microphone units (page 3
microphone units back to the base unit. See page 27 for wireless microphone unit registration
instructions.
Maintenance
Taking care of your ErisStation Conference Phone
Your conference phone contains sophisticated electronic parts, so it must be treated with care.
Avoid rough treatment
Place the wireless microphone unit down gently. Save the original packing materials to protect your
ErisStation Conference Phone if you ever need to ship it.
Avoid water
Your ErisStation Conference Phone can be damaged if it gets wet. Do not use the wireless microphone
unit outdoors in the rain, or handle it with wet hands. Do not install the base unit near a sink, bathtub
or shower.
Electrical storms
Electrical storms can sometimes cause power surges harmful to electronic equipment. For your own safety,
take caution when using electrical appliances during storms.
Cleaning your ErisStation Conference Phone
Your ErisStation Conference Phone has a durable plastic casing that should retain its luster for many years.
Clean it only with a soft cloth slightly dampened with water or mild soap. Do not use excess water or cleaning
solvents of any kind.
Remember that electrical appliances can cause serious injury if used when you are wet or standing in water.
If the base unit should fall into water, DO NOT RETRIEVE IT UNTIL YOU UNPLUG THE AC POWER CORD
AND TELEPHONE LINE CORD FROM THE WALL. Then, remove the telephone by the unplugged cords.
on the base unit, plug the power cable back to the power outlet.
37
within 1 second in Step 4.
)
. Register your wireless
and
Hide quick links:
Advertisement
Table of Contents
