Toyota Prius ZVW35 Series Dismantling Manual page 62

5. Remove the 9 bolts and inverter terminal cover.
6. Check the voltage at the terminals in the
inspection point in the power control unit.
Caution:
Wear insulated gloves.
To prevent serious injury or death, do not
proceed with dismantling of the HV system
until the voltage at the terminals in the
inspection point is 0 V.
Standard voltage: 0 V
Hint:
Set the tester to DC 750 Volts measure the
voltage.
7. Remove the rear No. 2 floor board.
(1) Using a clip remover, remove the 2 clips.
(2) Disengage the 3 fasteners and remove the rear
No. 2 floor board.
8. Remove the rear No. 4 floor board.
(1) Remove the rear No.4 floor board
sub-assembly.
9. Remove the auxiliary box LH
10. Remove the rear No. 2 floor board
sub-assembly.
(1) Disengage the claw and 2 clips, and remove the
rear No. 2 floor board sub-assembly.
57