Display - RCA Professional series Owner's Manual

Display

1
SIGNAL SELECT
DIGITAL DTS
ANALOG DIGITAL
1 SIGNAL SELECT indicators
Lights to indicate the type of input signal assigned
for the current component :
2 DIGITAL : Lights when a DOLBY DIGITAL
signal is played.
DTS : Lights when a source with DTS audio signals
is played.
ANALOG : Lights when an analog signal is selected.
DIGITAL : Lights when a digital audio signal is
selected.
2 DTS indicator
Lights when DTS mode is being used.
3 2 DIGITAL indicator
When the 2 (DOLBY)/DTS mode of the receiver is
on, this lights to indicate playback of a Dolby Digital
signal. However, 2 PRO LOGIC lights during two
channel playback of Dolby Digital.
4 Overload indicator
This lights when an analog signal is too high (the
SIGNAL SELECT would have to be on ANALOG). It
indicates the sound is distorting and the input signal
should be reduced.
5 ATT indicator
Lights when ATT is used to attenuate (reduce) the
level of the input signal (can only be used in
ANALOG mode).
6 DIRECT indicator
Lights when source DIRECT is in use. This function
bypasses all tone, balance, DSP and Dolby Surround
effects.
7 Speaker indicator
Shows if the speaker system is on or not. SP 3A
means speakers are switched on. SP 3 means
speakers are switched off.
8 MONITOR indicator
Lights when
MONITOR
recording as it is being made (see page 28).
2
3
DIGITAL
PRO LOGIC
9 0
is selected. Used to hear a
4 5 6
ATT
DIRECT
DSP
MIDNIGHT
LOUDNESS
- = ~
9 Character display
Shows the radio frequency or function (DVD/LD, CD,
etc.) receiver is using.
0 2 PRO LOGIC indicator
When the 2 (DOLBY)/DTS mode of the receiver is
on, this lights to indicate playback of a two channel
source.
- DSP indicator
Lights when any Advanced Theater or DSP mode is
selected.
= MIDNIGHT indicator
Lights when MIDNIGHT listening mode is in use.
~ LOUDNESS indicator
Lights when the LOUDNESS is on. Use to boost the
bass and treble at low volume.
! Tuner indicators
:
MONO
Lights when the mono mode is set using the
button.
:
TUNED
Lights when a broadcast is being received.
:
STEREO
Lights when a stereo FM broadcast is being received
in auto stereo mode.
@ Master Volume Level
Shows the overall volume level. Volume level is
maintained even when the power is off. ---dB
indicates the minimum level, and 0dB indicates the
maximum level.
• Depending on the level settings you make for
individual channels, the MAX level can range
between –10dB and 0dB.
Displays and Controls
7 8
MONITOR RF ATT
SP A TUNED
STEREO
MONO
! @
dB
MPX
19