Wick Assembly; Wick Replacement - Dyna-Glo RMC-11-C7 Owner's Manual

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
WICK ASSEMBLY- Check at least once a month!!
The burner assembly sits on top of the wick guide. Over time, tar deposits can
accumulate on the wick guide, and this can prevent the burner assemby from
seating properly. This can result in poor combustion, smoke, odor, etc.. To prevent
this from happening, tar deposits on the wick guide can be removed as follows:
Making sure that the heater is both cool and turned off, lower the wick to the "off" position.
Remove the batteries (located at the rear of the heater).
Remove the 2 guard bracket by removing 4 screws and lift off the grill assembly
as shown in illustration. (Fig. A)
Remove burner charnber.
Using the wick adjuster knob, raise the top of the wick until it is even with the top
of the wick guide. Using a flat-edge screwdriver, scrape off the tar deposits.
Be careful not to allow any of the tar deposits to drop into the grooves of the wick
guide. A small vacuum cleaner can be used to remove the tar deposits that have
been scraped off (Fig.B).
Reassemble the heater and replace the batteries.

WICK REPLACEMENT

The wick in your heater needs replacing if, after repeated cleanings, any of the following conditions still exist: slow to light,
hard movement of the wick adjuster knob, kerosene odor while burning, low heat output, slow warm up, damaged wick.
Use only a genuine replacement wick.
If cleaning the Wick does not improve performance, you will need to replace the Wick Refer to the "TROUBLE
SHOOTING GUIDE", see page 14. which outlines conditions under which the Wick should be replaced.
CAUTION : Use ONLY a genuine Replacement Wick. DO NOT attempt to substitute any other type of Wick device
or a Wick designed for another brand or model heater You could damage the heater and create a potential fire
hazard.
Call customer service at 1-800-668-5323, to order wick.
ATTENTION : The only tools needed to replace the Wick are :
A Pair of Pliers
1
. Push down the manual shut-off
Knob and turn the Wick
Adjustment Knob
COUNTERCLOCKWISE in the
direction of "OFF".
A Cross Screwdriver
2
. Use screwdriver to loosen and
remove 3screws that fix cabinet
base to fuel tank.
9
Fig.A
Fig.B
A Plastic Bag with a Twist Tie
3
. Use the Carrying Handle to lift the
Cabinet & Grill assembly straight
up and away from the heater.