Specification; The Front Panel - Speco PL200M User Manual

SPECIFICATION

Model:
Output p ower c apacity:
Frequency response: 50-17000 Hz (-3dB)
Totalh armonic d istortion:
Signal/noise r atio:
Inputs / s ensitivity-impedance:
Tone c
Outputs for s peakers / Ohms:
Outputs for s peakers / V olts:
Monitor o utput:
Phone o utput:
Line o ut: 1.2V
Controls:
7 Volume contr ols forCh1 -5, tel.pagina, monit or, phone
4 Mas ter volume control
5 Treble controls
5 Bass controls
4 Zo ne select switch for ea ch channel
4 Zo ne moni tor select switch.
1 AC select switch
Indicator:
4 Zo ne output-level meter
1 Moni tor output-level meter
Power s upply/ Consumption:
Dimensions:
Note: Specification, design and appearance are subject to change without prior notice!
PL200M
RMS:40W 4; Peak output: 90W 4
Less th an 0.5%(1KHz-nominal power capacity)
Microphone: Bet ter th an 55 dB rated output
Line:b etter than 6 0dB rated o utput
CH1-3/X LRa nd 6.3mm combination sock et: bal/unbal
Mic: - 42dB /-38dB-600ohm,bal/un bal.
Line: -26B/-20dB-15Kohm, bal/unbal.
LINE I N/ stereo RCA jack/ unbalanced
CH4: -10dB 5 0Kohm
CH5: 0dB 50Kohm
Ba ss 10dB-100Hz
Treble 10dB-10KHz
4 oh m , 8 ohm
25V-70V
1Wrms
0.5W into 47ohm
5 Gain controls for Ch1-5,
5 Mute controls
Power indicator
5 Mute indicators
115/230 V ac( 5%) -60/50Hz /400VA
483mm(W ) x 132mm( H ) x 310mm(D)
10

The Front panel

CH 1 CH 2 CH 3 CH 4
GAIN GAIN GAIN GAIN
TREBLE TREBLE TREBLE TREBLE
BASS BASS BASS BASS
MUTE MUTE MUTE MUTE
VOL VOL VOL VOL
Z1 Z2 Z1 Z2 Z1 Z2 Z1 Z2
Z3 Z4 Z3 Z4 Z3 Z4 Z3 Z4
Zone Zone Zone Zone
Selector Selector Selector Selector
1. Gain knob
This knob controls input gain. Turn the knob clockwise and the input
increases. Turn the knob counter-clockwise and the input decreases.
2. High knob
This is the treble control. You can use it to get rid of high frequency
noises or to boost the sound of cymbals or the high harmonics of
the human voice. The gain range goes from -10dB to 10dB with the
central frequency 10kHz.
3.Low knob
This is the Bass control. Boost male voice or kickdrum and bass guitar. Your
system will sound much bigger than what it is. The gain range goes from -10dB
to +10dB and the center frequency is 100 Hz.
4. Mute
Mutes the signals from the corresponding channel.
5. Mute LED
When the mute key is pressed down, mute LED lights up, and vice versa.
6. VOL knob
This knob controls volume. Turn the knob clockwise, and the volume increase s.
Turn the knob counter clockwise, and the volume decreases.
7. Zone selector
Z1, Z2,Z3,Z4 can be considered as signal assignment switches. Press the button
Z1 down and signal will be assigned to ZONE 1. Release the button and it stops
Assigning signal to ZONE1. Z2, Z3,Z4 can be operated in the same way.
8. Phone Volume
This knob controls the volume of the signal from the Phone system
(refer to 7). Turn the knob clockwise to increase the volume, and vice versa.
9. Phone
The amplifier signals can be sent to a pair of headphones
through this socket.
10. Monitor Volume
This knob controls the output signal level to monitor output.
CH 5 PL200M MULTI-ZONE DISTRIBUTION P.A. AMPLIFIER
GAIN ZONE 1 ZONE 2
VOLUME VOLUME PL
TREBLE
BASS
MON MON
POWER
MUTE
ZONE 3 ZONE 4
VOLUME VOLUME
VOL
Phone Monitor
Volume Volume
Z1 Z2
MON MON
Phone
Z3 Z4
Zone
Selector
1
2
3
4
6
7
Phone
Volume
Phone
8 9
3
ON
OFF
CH 1
GAIN
TREBLE
BASS
5
MUTE
VOL
Z1 Z2
Z3 Z4
Zone
Selector
Monitor
Volume
10