Monster Power HTS1650MP Owner's Manual page 12

TROUbleSHOOTInG
Symptom Possible Cause
The Unswitched LED The PowerCenter is not plugged in .
on front panel is Off .
The PowerCenter is plugged in,
but the outlet is not receiving power .
The Switched LED is Off . You are using the Switched Outlet
Remote Turn-On feature and haven't
plugged the plug into the component
you wish to use to activate the
Remote Turn-On .
The component remote control
you are using to power the Remote
turn-on has a dead battery .
The component you wish to use
to activate the Remote Turn-On
isn't plugged into a properly grounded
120 volt (nominal) outlet .
16
Remedy
• Plug the PowerCenter into a properly
grounded 120 volts (nominal) outlet
and make sure it is on .
• Plug the plug into the component
you wish to use to activate
the Remote Turn-On .
• Replace the battery powering
the component remote control .
• Plug the component into a properly
grounded 120 volt (nominal) outlet .
• Plug the PowerCenter into a properly
grounded 120 volts (nominal) outlet .
TROUbleSHOOTInG
Symptom Possible Cause
"Timed On" You are using the Remote Turn-On feature
indicator on front (Same as Switched) and haven't plugged
panel is Off . the plug into the component you wish to use
to activate the Remote Turn-On .
The component remote control you are using
to power the Remote turn-on has a dead battery .
The component you wish to use to activate
the Remote Turn-On isn't plugged into a
properly grounded 120 volt (nominal) outlet .
Video picture The incoming video signal is not
has rolling bars properly grounded .
or ghosting .
The PowerCenter The PowerCenter protection circuitry has
is emitting a loud sacrificed itself to protect connected equipment
buzzing alarm . from a catastrophic surge .
Remedy
• Plug the plug into component you wish
to use to activate the Remote Turn-On .
• Replace the battery powering
the component remote control .
• Plug the component into a properly
grounded 120 volt (nominal) outlet .
• Contact your cable or satellite provider
to correct your installation .
• The PowerCenter must be replaced.
See the Warranty Information section
for important details .
17