Omega FMG600 Series User Manual page 40

The display will read "Production date dd mm rrrr". This information cannot be edited. To return to the
Production data menu, depress any push-button, for example
Menu: Production data, depress
The display will read "Serial number xxxxxrr". This information cannot be edited. To return to the Production
data menu, depress any push-button, for example
Menu: Production data, depress
The display will read "Software v.xxxxx/xx". This information cannot be edited. To return to the Production
data menu, depress any push-button, for example
Menu: Production data, depress
Constant 1
Constant 2
To page through the menu items, use push-buttons
desired item and depress
value, use push-button
using push-buttons
sensor rating plate. Unless this not the case, the flow meter calibration is incorrect.
Menu: Production data, depress
The display will read "Sensor constant 1 xxxxxxxxx". The value was set during the meter calibration at the
manufacturing plant and it should not be changed. Depress
any key". Press any key, preferably
reappear on the display. The same procedure applies to setting the value of Constant 2. To return to the
Production data menu, depress push-button
Menu: Production data, depress
1 – 6.25 Hz
2 – 3.125 Hz
3 – 1.0 Hz
4 – 0.5 Hz
To page through the menu items, use push-buttons
desired frequency and depress
Menu: Production data, depress
The Manufacturing data menu will reappear on the display with the item "Excitation frequency" on the first
line.
Menu: Production data, depress
The display will read "Suppressed flow xxxxx". This parameter is usually set at 0.5% Qmax and may be
increased in cases where it can be demonstrated that while no fluid flows through the meter sensor, the
meter indicates a non-zero flow rate. Using push-button
increase/decrease the selected figure by push-buttons
equal to the desired value of suppressed flow rate. Depress
any key". Press any key, preferably
"Suppressed flow rate" selected.
Menu: Production data, depress
Design, Assembly and Service Manual
Induction flow meter FMG600 series
/ Serial number, depress
/ Software, depress
/ Sensor constants, depress
. The constant value will appear on the display. Should you wish to change this
to place the cursor under the selected figure and increase/decrease the same
and , respectively. The sensor constants shall be set at the values given on the
/ Sensor constants, depress
. This command will cause the menu Constant 1 / Constant 2 to
/ Excitation frequency, depress
.
/ Excitation freq., depress
/ Suppressed flow, depress
. The Production data menu will reappear on the display with the item
/ Language, depress
. The menu will reappear on the display.
. The menu will reappear on the display.
. The menu will reappear on the display.
(direction downwards) and
/ Constant 1, depress
. The display will read "Value entered Press
.
(direction downwards) and
/ 2 – 3.125 Hz, depress
move the cursor to the desired position and
and , respectively. Replace xxxx by a number
. The display will read "Value entered Press
Page 38 of 44
(upwards). Select the
(upwards). Select the