Table of Contents
Advertisement
Appendix F
Command Device / Group ID
ERDB
Device ID: 000 – 031
ERDR
Device ID: 000 – 031
Reading/parameter: a-s *4
ERDG
Group ID: 00A-00D, ALL
*5
EQNF
Device ID: 000 – 031
EQNG
Group ID00A-00D, ALL
EQPE
Device ID: 000 – 031
EQPG
Group ID: 00A-00D
ESPD
Device ID: 000-031, ALL
ESNM
Device ID: 000 – 031
ERST
Device ID: 000 – 031, ALL Reset Connector/Transmitter/all sensors Reset all sensors,
CRST
CSTS
FACTORY
AdminPassword
*1 Argument: 1 – 32767 (1 seconds to about 9 hours)
*2 Argument: xxxxxxxx (8 characters)
*3 and *4 See the following page
*5 Refer to Section 4.5.1 HTTPget using Port 2000
ASCII / TELNET COMMANDS TABLE
Description (see notes below if *)
Get sensor readings of Connector/
Transmitter
Get individual reading or parameter
Get sensor readings of a group /
groups of sensors
Get name, *3 status of Connector /
Transmitter
Get name, *3 status of a group /
all groups of sensors
Get sleep period, battery voltage, signal Get sleep period, for
strength, success, network address and sensor 15, EQPE015
parent address of Connector/Transmitter
Get sleep period, battery voltage, signal Get sleep period, of
strength, success, network address and group B, EQPG00B
parent address of a group / all groups
of sensors
Set the sleep period for Connector/
Transmitter / all sensors *1
Set the name of Connector/Transmitter *2 Set the name of
Reset wireless network
Get personal network ID, channel,
and the state of network stack
Sets the Receivers Ethernet configur-
ations to Factory Defaults
53
Example
Get reading for
sensor 15, ERDB015
Get the first temp. reading
for sensor 1, ERDR001c
Get readings for all
group B, ERDG00B
Get name, for sensor
15, EQNF015
Get name, for all
sensors, EQNGALL
Set sensor 15's sleep
period to 30 seconds,
ESPD015 30
sensor 15, ESNM015 z15
ERSTALL
Reset network, CRST
Get network information,
CSTS
FACTORY xxxxxxxx
xxxxxxxx is the Admin
Password
Advertisement
Table of Contents
