Setting A New Ip Address Over The Network - Omega Engineering UWTC-REC3 User Manual

4.2 Setting a New IP Address over the Network

Besides using the iConnect software, you may use the Receiver's default IP address to
access it and assign a new IP address to it.
The Receiver is shipped with a default IP address of 192.168.1.200 and Subnet Mask of
255.255.255.0. You can configure your PC's Network connection with an IP address that
is in the same range as the Receiver's IP address (192.168.1.x) and connect to the
Receiver using a crossover network cable between your PC and the Receiver.
With this completed, you can go to the DOS-Prompt and ping 192.168.1.200. If you
receive responses back (Figure 4.1), you can go to the Web browser and type in
http://192.168.1.200 and it will take you to the Wireless System' Home Page.
Access Control
Select
Access Control page were you can simply type in the desired Static IP address, and click
Save.
For more details about the "Access Control" page refer to Section 4.3.9.
ACCESS CONTROL
Address
For the IP address to take effect, the Receiver needs to be turned OFF and ON using the
"Network Reset" button. Pressing the physical button marked "RESET" on the Receiver
does the same thing.
You can now connect the Receiver to an Ethernet hub using a straight through cable,
power it up, and follow the ping routine mentioned in the previous section.
, button, you'll be asked for the password. You should be on the
http://192.168.1.200
ACCESS CONTROL
Login Password 12345678
Admin Password 00000000
Host Name
MAC Address 00:03:34:00:85:C4
IP Address 192.168.1.200
Gateway Address
Subnet Mask
Figure 4.4 Access Control
z85C4
0.0.0.0
255.255.255.0
Save Reset
Network Reset
Main Menu
14