Part 6: Specifications - Omega Engineering UWTC-REC3 User Manual

PART 6
SPECIFICATIONS
INTERFACE SPECIFICATIONS
Ethernet:
Supported Protocols:
LED Indicators:
Management:
Embedded WEB Server:
WIRELESS COMMUNICATION
Standard:
Frequency:
Network Topology:
Radio Power Output:
Limitations on Equivalent Isotropic Radiated Power (EIRP) levels in the
European Community and other countries applies. An improper combination of
power level can result in an EIRP above the allowed amount per regulations.
See Appendix H.
Data Rate:
Modulation:
Receiver Sensitivity:
Range:
The range assume a Line-of-Sight (LOS) between the Receiver and
Connector/Transmitter without obstructions or interference at which the
diagnostic signal strength web interface registers approximately 25%.
Antenna Frequency:
Impedance:
Connector:
POWER
Power Input:
Consumption:
Safety Qualified ac Power Adapter (included)
Nominal Output:
Input:
Standards Compliance IEEE 802.3 10Base-T (RJ45)
TCP/IP, ARP, ICMP, DHCP, DNS, HTTP, and Telnet
Network Activity, Network Link, Diagnostics, Receive and
Power
Device configuration and monitoring through embedded
WEB server
Serves WEB pages (Java™ Applets) containing real-time
data and live updated charts within definable time intervals.
IEEE 802.15.4, DSSS
2.4 GHz (2410 MHz), 12 Channels
Star Topology
100 mW (20 dBm), 10 mW (10 dBm)
Bit rate 250 Kp/s; Symbol rate 62.5 Symbol/s;
Chip rate 2000 kchip/s
Orthogonal Quaternary Phase Shift Keying (O-QPSK)
-100 dBm
The range depends on the specific Connector/Transmitter
used. Refer to the UWTC Manual for more specifications.
2400 to 2500 Mhz
50 ohm
Reverse Polarity SMA Plug
9 to 12 Vdc
2.5 W max.
9 Vdc @ 0.5 A
100 to 240 Vac, 50/60 Hz
43