Device Setting Setup And Configuration - Omega Engineering UWTC-REC3 User Manual

4.8.3 Device Setting and Configuration
Make sure that the Receiver is configured (using web access, see Figure 4.17) to the
settings below.
TCP Connection = any value from 1 to 5
Port number = 2000 (other values may be acceptable as long as Mail Notifier is setup
with the same Port number).
Then on the Mail Notifier Alarm Editor:
1) Set the "IP address" (for example 192.168.1.200).
2) Specify "Socket Number" 2000.
3) Set the "Address/RS485 Unit" to the Device ID number for a Connector/Transmitter.
4) Set the "Reading Cmd" using general commands in the Table below.
5) Define the Alarm Configuration (High/Low, High value, or Low value).
Specify Email Interval. This determines how many seconds each subsequential
alarm notification will be sent.
Determine Monitor interval. This establishes the interval or time resolution in
seconds for which readings will be obtained from the device.
Table 4.2 Mail Notifier Commands
Desired Value to Monitor
Reading A
Reading B
Reading C
Battery voltage (mV)
Signal Level
1. The devices are configured in Mail Notifier with symbolic commands rather
than actual device commands.
2. zRdgA with RS485 Device Unit # as 3, for example, is sent as ERDB003.
3. "Reading A" will be the first value returned for a device in response to a
command such as ERDB003.
Reading Cmd string
zRdgA
zRdgB
zRdgC
zBatt
zSignal
37
Actual Command String
(see Note 2)
ERDB003
ERDB003
ERDB003
EQPE003
EQPE003