Deck Belt Adjustment/Replacement - Honda HT-R3811 Owner's Manual

.7. Deck belt adjustment/replacement
mm
Never attempt to change a belt while. the engine is running.
Remove the engine key from the ignition and disconnect the spark plug cap to
prevent accidental start up.
CAUTION: Wear heavy gloves to protect your hands when replacing belts or
when working with the cutter blade.
n
Adjustment
1. Set the steering wheel in the straight-ahead position.
2. Move the P.T.O. lever to the ON (Engaged) position.
' 3. Lower the cutter deck as far as it will go with the cutter deck height adjusting
lever.
4. Loosen the 8 x 16 mm flange bolt, and pull the tensioner pulley outward un-
til the index mark on the tensioner arm aligns with the tension alignment
mark on the cutter deck. Hold the tensioner pulley in place, and retighten
the bolt.
INDEX MARK -ss
TENS,ONER AR[ 1
F!,NGE BOLT 81r 16 mm
TENSION ALIGNMENT MARK
PULLEY
47