Handlebar And Stem Installation - No Gyro Brakes - Huffy BMX bicycles Owner's Manual

Handlebar and Stem Installation - No Gyro Brake
WARNING: To prevent steering system damage and possible loss of control,
the "MIN-IN" (minimum insertion) mark (A) on the stem must be below the top of the
Locknut (B).
NOTE: Remove plastic Cap (E) from
the end of the Stem (11).
1. Insert the Stem (11) into the fork
(fi g 07).
2. Point the Stem towards the front of
the bike.
3. Tighten the Stem Bolt (C) just
enough to hold it in position.
4. If necessary, loosen the Handlebar
Screws (D) and rotate Handlebar
(28) into a comfortable riding posi-
tion.
5. Tighten Handlebar Screws (D) just
enough to hold it in position (fi g
08).
6. Align the stem with the front tire
and tighten the Stem Bolt (C) se-
curely (fi g 07).
WARNINGS:
• Do not over tighten the stem bolt. Over tightening the stem bolt can damage the
steering system and cause loss of control.
• If the handlebar clamp in not tight enough, the handlebar can slip in the stem.
This can cause damage to the handlebar or stem, and can cause loss of control.
10
C
A
fig 07
D
B
11
A
E
B